Now, launch LabVIEW and click tools -> MakerHub -> LINX -> LINX Firmware Wizard to deploy the LINX firmware to the chipKIT. Under the BM options, change the latency timer to 1 ms. Once the drivers are installed, right click on the COM port for the chipKIT WF32 and click properties then click on port settings and choose advanced. If the drivers were not installed properly, download the drivers for your device which are included as part of MPIDE found at. The COM port is the chipKIT WF32 and if the drivers were not installed correctly, a yellow exclamation mark will appear over the device. To make sure, open the device manager from the control panel and expand the Ports section. Windows will most likely install the device drivers automatically. With all the required software installed, connect chipKIT WF32 to your PC using a USB A to mini B USB cable. A detailed installation instruction video can be found by clicking on "Getting Started." Once that is completed, install LabVIEW MakerHub LINX here by clicking on download now from the attached page. Next, install NI VISA here if you did not include it in your LabVIEW installation. If you have installed LabVIEW, chipKIT WF32 drivers, and LabVIEW MakerHub LINX already, you can skip this step.įirst, install LabVIEW onto your computer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |